Area to ask questions regarding issues with your snowmobiles. We have some Great mechanics here.
started up today warmed it up went to take off and sec clutch went wide open and stuck and worked it loose tried it again did it again and now pri clutch seems to be stuck wide open as is sec clutch whats going on....its a blizzard today so didnt mess with........clutch rebuilds? oh yea has...
I was wondering if Ice scratchers are the answer to riding in marginal conditions, low snow and warm weather...any of you freaks have any experience with them good or bad??? Temp light came on a few times yesterdy and the gage said 190 degrees :tas:
Ive got a 20 hp vtwin honda engine ina piece of equipment here. The unit is only 3 years old. The batt keeps going dead. What wires do I test the voltage? Or is tehre a test for something else??? Thank guys Rot.
As everyone here knows, I put a F series suspension into my Zr900 this season. But in the 1100 mi that i rode it the front shock mounting point worked loose from the constant banging at our local riding area and wore out the holes where the lower shock mounts. Egged them out pretty bad so I took it...
I have an 04 F-7 and just noticed again I am new with this bare with me. I think it is the rear idler wheel is shot it looks as if it is worn out and the bearing is gone. Correct me if I am wrong at all please I need help I am going away with a friend next week riding and need to get the sled...
I was going over my sleds today and noticed on my 99 mxz 600 i have a track bar showing only about 3/4 to an inch on the outside probalby from sliding the ass alot:D but the track is only 2 years old the original was studded but i bought an m-10 2 yrs ago at the bigeast show and they told me the...
Help, Runs and starts great. After 1/4 throttle looses power but will go back to good idle. Done lots of stuff. New coil,fuel pump, used CDI, All electrical seems to check out. replaced one failed fuel injector. Throttle shims good. Power reeds and compression good.Any Ideas what to do next?...
Friend has a 95/96 (not sure of year) polaris ultra I was wondering what the clutch should engage at. any help would be appreciated, thanks...
What could cause this?? The plugs are a light brown.
i am working on my brother zr 580.....it was at friends place in storage for several years his friend got it out and run it for a ride or two it then died and wont start again...it will start and kinda run some times for a few seconds full throttle but not run right...i suspect fuel system...
friend of mine has a turboed 900 2009 dragon he says it run great last year but then had some recall done on engine and they reflashed it 2010 program now run like crap....less power than another friend that has stock 2010 900 dragon any ideas?
im a polaris guy so kinda stumped on this one.im working on a 07 600sdi that had minor detonation on mag cylnder.tore it down and the crank bearing grease is polluted and black on the outer greased bearings.so im thinkin he had 2 problems.plugged or frozen injector that leened out the one side...
I was wondering if having a bad leak would make the sled bog down alot? Just wondering cause I just rebuilt the engine and cant get a donut for it for a couple days.
I have a 2000 formula z 700 that needs to new inner bogie wheels, one is gone and the bearings are shot how do i go about getting the old one off and the new ones on?
Got a 2001 arctic cat Panther 550 2up. The brake seem to stick on. Checked the caliper and pads, seems ok. lines good that i can tell. Any sugestions? thanks JB:D
does anyone know if ski-doo had issues with their belts comin apart? if not what are the specs for the clutch alignment on the rev 600 renegade? thanks!
need some suggestion on chain case oil. my local cat shop is nolonger selling cat or polaris:(. dont need hitech just something that wont be too thick in the cold. thanks a bunch:D
Ok folks, you all prob. heard me rave about INJEX oil. Well 2 days ago my old 1995 XLT600SP( sold it w/ 12000 miles on it) came in the shop for necessary repairs. A tie rod end broke and just a basic servivre. The new owner said its very hard statring but once running it fine. I yank the engine to...
hello, i have 97 zrt with 900 tripple port & polished 150 psi delta force reeds & spacers 39-24 gears, motor is bad fast and clutches seem to be working great. My question is i was looking at primary after ride and noticed that the belt is not coming all the way to top. Can anyone tell me what...
I am having Grief with my wife's 97 500 Formula- seems it likes to suck coolant into cylinders and or case after a warm day ride have had it apart 3 times -warped head?? or ?? Any one else experience this and or find the sweet spot fix for this problem or just me-am putting all gaskets and...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
